Forums

hello, I am switching from brassler endosequence files   to   edgefiles x7   04 taper.      I  Need info on what rpm to run them at,   I was using 500-600 rpm with my endosequence files,        I use and electric handpice by aseptico and it  has settings for torque  from 1 to level 3 which is full torque.      

Dr nydegger, can you please tell us what   sequence of files you  used and at what   RPM AND TORQUE?  THANK YOU

"Too Much Wisdom" Final X-Ray: Case Summary: #32- Symptomatic IP with symp. apical periodontitis Pt had throbbing pain for several days related to this tooth CBCT showed M root curving severely in D direction and D root curving in 2 planes: D and B Files & Products Used: I opened up the coronal and middle third with Protaper Gold S2. Hand filed apical with #8,10,15 K files and ;astly used EdgeEndo X7 20.04, 25.04 and finished with 30.04. Lots of irrigation with NaOCl, towards the end EDTA, then MTAD. Obturation: Warm vertical with BC sealer EdgeEndo did a great job shaping the apical part. That was my first time using EdgeEndo in a curved case, and it worked! Additional X-Rays & Extras: View full case

​Most likely radiographic overlap of MB1 and MB2.

Wisdom anatomy Final X-Ray: Case Summary: Lower 3. Molar retreatment case HERO 642 25.04 for old fillings FKG XP Endo Shaper 35.04 FKG XP finisher R with NaOCl Irrigation with NaOCl and EDTA under activation (1 min per canal) with EndoUltra Lateral condensation Single visit treatment Files & Products Used: FKG XP Endo Shaper Additional X-Rays & Extras: View full case